Learn how your laser works
What's on this page
- • The dot and the DPI it can use, with a slider for each
- • Photos as dots: why DPI and dithering decide a photo engraving
- • Focus: why a short lens is sharper and a long lens is more forgiving
- • Kerf: why a cut has width, and why its sides lean
- • Power, speed and passes as energy on each millimetre
- • Each kind of laser: diode, CO2, CO2 galvo, fiber, MOPA and UV
- • Galvo lenses from F100 to F420: field size against dot size
- • How heat makes colour on steel and titanium, and black anneal marks
- • The holographic effect: rainbows from fine lines
- • MOPA against a standard fiber laser, pulse by pulse
How to use it
- 1. Pick a lesson from the buttons at the top.
- 2. Move its sliders and watch the diagram and the numbers change.
- 3. Take what you learned to a test: the tools below make the file.
Questions
What DPI should I engrave at?
About 25.4 divided by your dot size in mm. A 0.08 mm dot gives about 318 DPI. Going much higher only overlaps the lines: darker and slower, with no extra detail.
Why does a fiber laser have a smaller dot than a CO2 laser?
Mostly the wavelength. Light can't be focused much tighter than its wavelength allows, and CO2 light is about ten times longer than fiber light.
How does a laser make colour on stainless steel?
Heat grows a clear oxide skin on the surface. Light reflecting from the top of the skin and from the metal under it mixes, and the skin's thickness decides which colour is left. Enough heat turns it black.
What is the difference between MOPA and a standard fiber laser?
Both make the same light and the same dot. A MOPA lets you choose how long each flash lasts and can flash far faster, which gives gentle, even heat for colours and black marks.
Are the numbers exact?
No. They are typical estimates from the usual optics rules, a guide only. Your machine's manual and a test on scrap come first.
Try next: Metal Marking Simulator, Test Grid Generator, Photo Test Chart.
